port side interior face glassed,
note taper on inside ends to accommodate future glass overlap into the trunk
note taper on inside ends to accommodate future glass overlap into the trunk
starboard side glassed inside,
fillets were spread on inside corners before laying the cloth
daggerboard trunk halves assembled,
note long handled spatula for spreading the inside fillets on the port side
note long handled spatula for spreading the inside fillets on the port side
ready for glass cloth on exterior
exterior port side and end are glassed,
flipped over and exterior starboard side glassed,
planks support the trunk and keep the wet underside from touching the table
top, keel, and rail pieces
exterior of trunk sanded ready for finish coat
how the support pieces install
laminated keel pieces are curved
finished daggerboard trunk
the support pieces will be epoxied in place after the trunk is installed in the setup
No comments:
Post a Comment