Making cedar veneer - lots of it!

Planing 1/8" red cedar veneers 

each hull gets 3 layers

approx 1200 sq ft needed for floats and mainhull

Bandsaw and Planer

Walker Turner 16" bandsaw with 5 hp electric motor

• used a 1" x 4 tpi bimetal blade with alternate set teeth for ripping fir and cedar planks to rough size for stringers, gunnels , keels - blade speed 2400 feet/min.
• used a Doall 1" x 4 tpi honeycomb knife blade with "0" set teeth and 0.032" kerf for slicing 3/16" cedar strips up to 10" wide (DOALL028) - similar to a hollow ground saber saw blade
• the cedar veneer was sawn to about 3/16", then planed both sides to 1/8"
• Ryobi 13" planer was used for planing to finish sizes, removing about 1/64" per pass for the veneer
• 1/8" cedar veneers were passed through the planer on a true flat 2"x10" spruce plank for support
• the bandsaw and planer were mounted 10 feet from the feed end of a 26 foot x 18" bench
• a 24"x24" door was located in the garage wall at the feed end of the bench, and when open 16 foot stock could fit on the feed end by sliding out through the small door

Stringer and gunnel details

 stringers with breast hooks at stem

 detail at frame 8

detail at frame 9 and keel for drainage

 stringers with breasthooks at stern

 stringers at bow - plenty of strength

 gunnel doublers tapered at ends

Note tapered stringers to avoid hard spots

Float - stringers and gunnels added

Note the doublers on stringers and gunnels for strengthening